Toll Free: +1 (800) 523-7867
|

Stop It® Pipe Repair System

Fix Stix®

Chemical Resistance Products

FIX STIX®

FIX STIX® epoxy is a hand-moldable, industrial-strength, steel-reinforced epoxy that plugs leaks, fills holes and cracks – and that will bond and repair anything made from steel. Conformable, safe and simple-to-use, this putty can be used by nearly any member of your team to quickly make a repair that can save several hours and significant money.

This industrial strength polymer can be molded into shapes to patch and repair almost anything. Each stick contains pre-measured amounts of resin and activator. It is non-flammable, no VOCs.

  • Sets rock hard in 20 minutes in a wide range of temperatures, so your pipe is pushing resources in less time than it takes to go out for a cup of coffee.
  • No hot work, measuring or special tools required. FIX STIX® comes ready to use – everything you need to repair the pipe is right there.
  • Pre-measured, non-toxic, solvent-free, and with little odor, so it’s simple and safe to use.
  • Will not shrink, crack or pull away and has exceptional chemical resistance, so you can expect a long life from the repaired portion of the pipe.
  • Works underwater and over a wide temperature range.
  • Highly resistant to corrosion or deterioration by dilute acids and caustics and will withstand the influence of mildly acidic water.

If you don’t want your application having a “repaired” look, FIX STIX® can be machined, threaded and painted after it has fully cured.

FIX STIX™ epoxy pipe repair
Epoxy Pipe Repair
Steel Pipe Epoxy

Working Time: 2 minutes

Set Time: 20 minutes

Maximum Use Temperature: 300°F (149°C)

Dielectric Strength: 300 volts/mil at 0.15 cm

Volume Resistivity: 1 x 1012 ohms/cm

Density: 18.5 lb/gal (2.2 gm/cm3)

Compression Strength: 12,000 psi

Tensile Strength: 6,000 psi

Modulus of Elasticity: 6 x 105 psi

Lap Shear Strength (steel): 900 psi

Izod Impact: 0.3 lb/in (notched)

Hardness (Shore D): 80

Part No Description Case Quantity Case WT 
(lbs)
34978 Hand Moldable Epoxy 28 4.75

Shelf Life at 75° F (24 °C): Minimum 24 months

Working Time: 2 minutes

Set Time: 20 minutes

Maximum Use Temperature: 300 °F (149 °C)

Complete the form below to request documents.

* Indicates Required Selection

"*" indicates required fields

Please select each product for which information is being requested. Multiple products may be selected at the same time. Documents will be immediately forwarded by email.
For which products are you requesting documents? (select all that apply)*

close-link
error: Content is protected !!