viscotaq-banner
Print

Fusion Tape™ - Technical Information

Fusion Tape™ Physical Properties

Operating Temperatures (Intermittent): -85°F to 500°F (-65°C to 260°C)
Operating Temperatures (Continuous): -76°F to 392°F (-60°C to 200°C)
Dielectric Strength, Minimum: 400 volts/mil (.020" thick)
Dielectric Constant, 1 KHz: 2.95ptape
Dissipation Factor, 1 KHz: <.0004
Volume Resistivity: 3 x 1014 ohms/cm
Cold Brittle Point, Maximum: -65°C
Water Absorption: 3% maximum by weight
Tensile Strength: 700 psi minimum
Ultimate Elongation: 300% minimum
Tear Resistance: 85 ppi
Durometer Hardness: 50 Shore A room cured 24 hours
Meets or Exceeds: U.S. Military Spec A-A-59163 (formerly MIL-I-46852C) Type II Triangular Guideline and Type I, Rectangular, Self-fusing silicone rubber tape.

msds_icon_50x47 Materials Health, Safety And Environmental Sheet - (pdf)

Flyer - (pdf)

About InduMar

InduMar Products, Inc. has been providing leak repair solutions for 25 years. We operate in all markets where pipe leaks are a problem. In particular our areas of expertise lie in:

  • Refinery/Petrochemical
  • Offshore oil and gas production
  • Commercial Marine
  • Mining
  • Power

"We used STOP IT® on a 1" stainless steel pipe used as a conduit for wiring our sensors in our cargo tanks– the sensors measure the level of cargo in the tank. The 1" pipe developed a crack allowing gasoline to damage the sensors. We used STOP IT® to repair the crack until it could be welded. STOP IT® is a great product, keep up the good work!"

A Chemical Tanker out of Louisiana