Toll Free: +1 (800) 523-7867

Stop It® Pipe Repair System

Fix Stix™

Chemical Resistance Products


FIX STIX™ epoxy is a hand-moldable, industrial-strength, steel-reinforced epoxy that plugs leaks, fills holes and cracks – and that will bond and repair anything made from steel. Conformable, safe and simple-to-use, this putty can be used by nearly any member of your team to quickly make a repair that can save several hours and significant money.

This industrial strength polymer can be molded into shapes to patch and repair almost anything. Each stick contains pre-measured amounts of resin and activator. It is non-flammable, no VOCs.

  • Sets rock hard in 20 minutes in a wide range of temperatures, so your pipe is pushing resources in less time than it takes to go out for a cup of coffee.
  • No hot work, measuring or special tools required. FIX STIX™ comes ready to use – everything you need to repair the pipe is right there.
  • Pre-measured, non-toxic, solvent-free, and with little odor, so it’s simple and safe to use.
  • Will not shrink, crack or pull away and has exceptional chemical resistance, so you can expect a long life from the repaired portion of the pipe.
  • Works underwater and over a wide temperature range.
  • Highly resistant to corrosion or deterioration by dilute acids and caustics and will withstand the influence of mildly acidic water.

If you don’t want your application having a “repaired” look, FIX STIX™ can be machined, threaded and painted after it has fully cured.

FIX STIX™ epoxy pipe repair
Epoxy Pipe Repair
Steel Pipe Epoxy

Working Time: Two Minutes
Set Time: 20 minutes
Maximum Use Temperature: 300°F (149°C) Dielectric Strength: 300 volts/mil at 0.15 cm
Volume Resistivity: 1 x 1012 ohms/cm
Density: 18.5 lb/gal (2.2 gm/cm3)
Compression Strength: 12,000 psi
Tensile Strength: 6,000 psi
Modulus of Elasticity: 6 x 105 psi
Lap Shear Strength (steel): 900 psi
Izod Impact: 0.3 lb/in (notched)
Hardness (Shore D): 80

Part NoDescriptionCase QuantityCase Wt. LBS
34978Hand Moldable Epoxy285

Shelf Life at 75° F (24 °C): Minimum
24 months
Working Time: Two minutes
Set Time: 20 minutes
Maximum Use Temperature:
300 °F (149 °C)
Dielectric Strength: 300 volts/mil
Density: 18.5 lb/gal (2.2gm/cm3)
Compressive Strength: 8,000 psi
(55 MPa)
Tensile Strength: 6,000 psi
Lap Shear Tensile Strength: 900 lbs
(6.2 MPa)
Izod Impact: 0.3lb/in (notched)
Hardness (Shore D): 80
Non-Volatile Content: 100%

Complete the form below to request documents.

* Indicates Required Selection
  • Please select each product for which information is being requested. Multiple products may be selected at the same time. Documents will be immediately forwarded by email.