Stop It® Gas Riser Rehabilitation Kit


The STOP IT® Gas Riser Rehabilitation Kit is intended to strengthen the structural integrity
of the riser nipple, or riser casing on non-leaking 3/4” and 1” standard anodeless risers.
It is comprised of a strong knitted fiberglass tape coated with fast setting, water-activated
urethane resins. The STOP IT® Gas Riser Rehabilitation Kit also includes FIX STIX™, a steel
filled hand moldable epoxy that sets rock hard in only 20 minutes

Tested by the Gas Technology Institute to specific clauses of Gas Industry Standard (GIS) LC8-1:2006 Specification for Methods of Repairing Leaking Ferrous Gas Mains.

The STOP IT® Gas Riser Rehabilitation Kit is a necessary item in an inventory of products
for minimizing corrosion-related operating costs.

Kit Contents:

  • STOP IT® knitted fiberglass tape precoated with water-activated polyurethane resins
  • FIX STIX™ hand moldable epoxy
  • Gloves for easy clean up
  • Detailed directions

Jump to technical specs

Order Stop It® Gas Riser Rehabilitation Kit

Stop It® is a registered trademark of InduMar Products, Inc.



  • Riser reinforcement and protection
  • Re-strengthening corroded pipe
  • Corrosion protection
  • Air to soil interface


  • One person, no special tools
  • Simple and easy to install
  • No VOCs
  • Does not crack
  • Easily conforms to irregular shapes


  • Improves effciency of utility field personnel
  • Reliable installation quality
  • Reduces shut downs or relights
  • Reduces customer downtime

Read the GTI Report on the Stop It® Gas Riser Rehabilitation Kit



Stop It Riser Rehabilitation Kit 2

Technical Information

Stop It® Gas Riser Pipe Rehabilitation Kit Data Sheets 

Contact us to learn more or purchase Stop It® Gas Riser Pipe Rehabilitation Kits

Physical Properties

Shelf Life:
2 years from date of purchase

Pressure Retention Capacity:
Recommended for pressures up to 400 psi (28 kg/cm2, 27 bar)

Temperature/Heat Resistance:
From -20°F up to 250°F (-29°C to 121°C) – continuous.
From 250°F to 500°F (121°C to 260°C) – intermittent

Set Time:
Tack free in 3 – 5 minutes at ambient temperatures of 50°F to 80°F (10°C to 27°C)

Cure Time:
Cures in 30 minutes at temperatures between 50°F to 80°F (1O°C to 27°C)

Tensile Strength:
ASTM D 3039, 24,950 PSI / in width/172 MPa

Flexural Yield Strength:
ASTM D 790-1-B, 12,005 PSI (844 kg/cm2)

Durometer Hardness:
ASTM D 2240, 63 (Shore D)